True ±0.012% of reading accuracy

Source and Read 0.000-24.000 mA

Simulate 2-Wire Transmitters Power 2-Wire Transmitters and Read 0.000-24.000mA

Display current in mA or -25.00-125.00 % of 4-20 mA

Read 0.00 to ± 30.00 VDC with 4X over range ability

Source 0.000 to 24.000 VDC with up to 20mA output

Direct Calibration 1.000V to 5.000V

Auto Step or Ramp

Selectable step sizes, time in-between steps & soak time

Full 5 Digit Display

Uses (1)  9 Volt alkaline battery

Superior battery life of 40 hours under typical continuous usage

Easy access to battery compartment

240 VAC Tolerant

Current Leak Detection

Check all loop parameters such as Current, Voltage, Resistance, AC Voltage and Ground Fault errors

The Piecal 532 4-20 mA/Voltage Loop Calibrator with Loop Diagnostics is the best tool for calibration, test, and diagnosing process loops. The Piecal 532 brings all the features you would expect from a loop calibrator and timesaving ones. Make adjustments with the EZ-Dial knob or test limits with the Dual Action EZ-Check switch. Powerful ramping functions are only a button away on the Piecal 532. Save potentially hours of troubleshooting time on problem loops with the Piecal 532’s unique Loop Diagnostic Mode.

In Piecal's 532 Loop Diagnostic Mode, the loop current, voltage, impedance, AC voltage, and mode of operation are all displayed simultaneously eliminating the need of a DMM connection. Loop diagnostics is available in every mode of operation and truly is a diagnostic monitor, as parameters are continuously updated in real time. The smart diagnostic tool even indicates the most likely cause of loop failure! Loop Diagnostic features the ability to measure ground fault error caused by faulty wiring, flooded conduit and corrosion bridges.

제품사양